Alphane Moon@lemmy.worldM to Hardware@lemmy.worldEnglish · 3 days agoPhilips debuts 3D printable components to repair productswww.tomshardware.comexternal-linkmessage-square93fedilinkarrow-up1691arrow-down15
arrow-up1686arrow-down1external-linkPhilips debuts 3D printable components to repair productswww.tomshardware.comAlphane Moon@lemmy.worldM to Hardware@lemmy.worldEnglish · 3 days agomessage-square93fedilink
minus-squareconicalscientist@lemmy.worldlinkfedilinkEnglisharrow-up7·2 days agoThey were replaceable in the old Norelco shavers. It required soldering. If you’re 3D printing then soldering is on the same level of technical skill. There’s even a solder bridge to disconnect the battery.
They were replaceable in the old Norelco shavers. It required soldering. If you’re 3D printing then soldering is on the same level of technical skill. There’s even a solder bridge to disconnect the battery.